Red-D-Arc EXTREME 360 Specifications download pdf (Page 7)

2.RJ45 patch cables category 5 that connect the ArcPower 360 each other are wired 1:1,that is,pins with the

same numbers are connected together.

Pin 1: Not used Pin 1: Not used

Pin 2: Not used Pin 2: Not used

Pin 3: Not used Pin 3: Not used

Pin 4: Not used Pin 4: Not used

Pin 5: Not used Pin 5: Not used

Pin 6: Data + Pin 6: Data +

Pin 7: Data - Pin 7: Data -

Pin 8: GND Pin 8: GND

5.Installing instructions.

5.1.DMX operating

1.Unplug from the mains before installation.

2.Connect the LED modules to the xture.

3.Connect the DMX controller to the xture

4.Connect the xture to the mains

5.Set the DMX address on the control board of the xture (see chapter "Control board").

Warning!

Accidental connection DMX 512 Input/Output to non-DMX 512 device (e.g.Ethernet

network Hub) can damage the ArcPower 360.

Maximum total cable length between one LED zone output of the Arcpower 360

and all its connected LED modules is 80 metres.

Single ArcPower 360 installation:

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Red-D-Arc EXTREME 360 Specifications Page 7